HP StorageWorks XP Remote Web Console Software - Manual (Page 192)

2. In the LDEV Information table, right-click the normal LDEVs, CVS volumes, or LUSE volumes you
want to form the LUSE volume, and select Set LUSE Volume.
A pane appears. If the displayed pane asks if you want to perform a Volume Manager operation
on a volume that has a path definition (see
Figure 85 ), follow step 2a. If the displayed pane asks
if you want to perform a Volume Manager operation that affects more than one SLPR or CLPR,
follow step 2b. If the Set LUSE Confirmation pane appears, follow step 2c.
a. To perform a Volume Manager operation on a volume that has a path definition (see Figure
85 ), click OK. If a message appears asking whether you want to perform a Volume Manager
operation that affects more than one SLPR or CLPR, go to step 2b. If such a message does
not appear, go to step 3.
If you do not want to perform a Volume Manager operation on a volume that has a path
definition, click Cancel. The previous pane appears, and you can retry the operation.
b. To perform a Volume Manager operation that affects more than one SLPR or CLPR, click OK.
A confirmation pane appears. Go to step 3.
If you do not want to perform a Volume Manager operation that affects more than one SLPR
or CLPR, click Cancel. The previous pane appears, and you can retry the operation.
c. If the Set LUSE Confirmation pane appears, go to step 3.
3. Click OK to create the LUSE volume (or Cancel).
NOTE:
New settings appearing on the pane in blue bold italics are not yet registered to the array.
You can reset LUSE volumes that have been created but not yet registered to the array (in
blue bold italics) to the state they were in before they were created (see
Resetting unregistered
LUSE volumes ).
4. Click Apply (or Cancel).
5. Click OK (or Cancel).
Releasing LUSE volumes
CAUTION:
Releasing LUSE volumes is a destructive operation. Move and/or back up data before proceeding.
Delete all SCSI paths to the LUSE volume you want released.
1. In the Volume Manager pane, select the CU number from the LDEV Information tree. The LDEV
Information table displays all LDEVs in the selected CU.
2. In the LDEV Information table, right-click a LUSE volume, and select Release LUSE Volume. The
Release LUSE Confirmation pane appears.
3. Verify that the LUSE volumes listed in the confirmation pane are the ones you want released.
Volume Manager operations 192