Copying paths from one nas port to another – HP StorageWorks XP Remote Web Console Software User Manual
Page 113
3.
To copy all LU paths defined to a host group, complete the following steps to copy the host group
or iSCSI target:
a.
In the tree, right-click the host group, and select Copy. The selected host group or iSCSI
target turns green.
NOTE:
If you right-click a host group or iSCSI target for an initiator port, you cannot copy
paths.
b.
Right-click the copy destination port, and select Paste. If a confirmation message appears,
click OK.
NOTE:
You cannot paste paths to initiator port.
4.
To copy one or more (but not all) LU paths defined to a host group or iSCSI target, complete the
following steps:
a.
In the tree, select the host group or iSCSI target.
b.
In the LU Path table, select one or more LUNs to which volumes are assigned. (If a volume
is assigned to a LUN, columns on the right of the LUN column are not empty.)
c.
Right-click the selection, and select Copy Paths. The selected LUNs turn green.
d.
Double-click the copy destination port to display host groups or iSCSI targets below the port.
e.
Right-click the host group to which you want to paste paths, and select Paste Paths. If a
confirmation message appears, click OK.
NOTE:
You cannot paste paths to host groups or iSCSI targets for initiator ports.
5.
Click Apply. A confirmation message appears.
6.
Click OK. Settings are applied to the array.
Copying paths from one NAS port to another
CAUTION:
Before taking the following steps, see
for important information.
1.
Start XP LUN Configuration and Security Manager Software, and display the XP LUN Configuration
and Security Manager Software pane (
).
XP LUN Configuration and Security Manager User Guide
113