Canon VB-C60 User Manual
Page 264
9-22
Messages List
Adding/Editing
a Camera
Server
This camera server has already been set
up without recording. Please check your
settings and try again.
When a camera server configured as [Do
not record] is already added, an attempt
was made to add or edit a camera server
using the same hot name/IP address and
port number.
Connection to the camera server could not
be established.
Please verify that the host name or IP
address, user name, and password are
correct.
Could not connect to the camera server.
The storage server of this version does not
support the specified camera.
You attempted to register VB-C500VD,
VB-C500D, VB-C60 or VB-C300 with an
older version of the Storage Server.
Add/Edit
Camera
Server dialog,
Add/Edit
Recording
Schedule
dialog, Motion
Detection
Settings
dialog, Sensor
Event Settings
dialog
Connection to the camera server has been
lost.
An error relating to the camera server
connection occurred.
Failed to connect a camera server.
An unknown error relating to the camera
server connection occurred.
Add/Edit
Recording
Schedule
dialog
At least one day must be selected.
[OK] was pressed without specifying the
weekday.
At least one type of recording must be
selected.
[OK] was pressed without selecting the
recording mode check box.
The recording frame rate must be between
'
[OK] button was pressed after entering an
invalid frame rate.
You cannot use digital zoom when
[Custom] is selected.
Attempted to close the Add (Edit) Schedule
Item with VB-C60 digital zoom specified
while [Custom] was still selected.
If Night Mode is set to [Auto], please
confirm that exposure is set to [Auto] in the
camera control panel.
[Night Mode] was set to [Auto] while
exposure was not set to [Auto] in the
camera control panel.
Messages
Cause