Canon VB-C60 - Manual (Page 132)

4-52
Set Motion Detection Recording
Step 6: Set frame rate and pre and post event recording duration
1. [Max. Frame Rate] - select a maximum frame rate for recorded video from the drop-down menu. Choose
from 0.1 frames per second to 30 frames per second (5 is the default).
2. [Record for] [sec. before event] - enter a number of seconds for the amount of recording time before the
event occurs (up to 30 seconds).
3. [Record for] [sec. after event] - enter a number of seconds for the amount of recording time after the event
occurs (up to 999 seconds).
Step 7: Set the [External Outputs]
Click the drop-down menu for the target external device and set [On] or [Not specified].
Click [OK] to save the new settings and close the dialog.
Click [Cancel] to discard the new settings.
Note
z If [Continuously at Max.] is also selected, Record for before event is not available.
z If Record for before event is set, it will take approximately 10 seconds after event occurrence until its
display in the viewer.
z If the resolution is set to MPEG-4, the frame rate set in the VB-C500VD, VB-C500D or VB-C60 becomes
enabled.
Note
Available external outputs depend on the Camera Server.
Note
Even with 0 seconds set to [Recorded for __ sec. before event] and [Recorded for __ sec. after event] fields,
video is still recorded while motion is being detected.
Tip
See Chapter 6 for optimizing the Motion Detection operation.