West Control Solutions MRC 9000 User Manual

Page 97

Edition 3

Rev G

Section 4

4-15

A
N

C
U

C
U
R

V
E
S

2. Press the

to advance to the next parameter, VALUE.

3. Press the

and the display advances to the next constant to be programmed. Refer to the beginning of

this section, page 4-14.

4.1.3 CUSTOM CURVES

Custom Curves are available only when MATH has been specified and present in the model number order matrix.

Custom Curves allow the user to define up to 21 point "custom curve".

From the Normal Display, press the

until CONFIGURATION is seen in the lower display line. If PASS-

WORD appears in the lower display line, the correct "password" will need to be entered before access to Con-

figuration is allowed. If CONFIGURATION is not displayed, then Configuration has been disabled. Refer to

Section 9, Enables and Passwords, for instructions to enable Configuration.

With CONFIGURATION in the display, press the

, then the

until CUSTOM CURVES appears in the

lower display line.

(Continued on next page)

Press the

to change, then

desired position, then

to desired number,

then press the

. This will change the value (left number). Then change the exponent (right number) and

then press

CVx VALUE
1.00000 E 0

Selections

-9.99999E37 to 9.99999E37