Cx display ramped sp not displayed, Cx display % outputs not displayed – West Control Solutions MRC 9000 User Manual

Page 248

background image

Edition 3

Rev G

Section 13

13-17

26.Press the

to advance to the next parameter, DISPLAY RAMPED SETPOINT.

Cx DISPLAY RAMPED SP

NOT DISPLAYED

Selections

NOT DISPLAYED

IN CONTINOUS MODE

IN SEQUENTIAL MODE

IN BOTH MODES

27.Press the

to advance to the next parameter, DISPLAY % OUTPUTS (only if either output is propor-

tional).

Cx DISPLAY % OUTPUTS

NOT DISPLAYED

Selections

NOT DISPLAYED

IN CONTINOUS MODE

IN SEQUENTIAL MODE

IN BOTH MODES

28. Press the

and the display advances to the next controller to be programmed. Refer to the beginning of

this section, page 13-3.

Press the

to change,then

, to

desired choice, then press the

.

Press the

to change,then

, to

desired choice, then press the

.