West Control Solutions MRC 9000 - Manual (Page 141)

Edition 3
Rev G
Section 4 4-59
12. Press the to advance to the next parameter, TOTALIZER PRESET.
Note: Units are that of TOTAL.
* Total Decimal Position
13. Press the to advance to the next parameter, LOW FLOW CUTOFF.
Note: Units are that of INPUT (RATE). If no units were selected, the display will show - NONE -.
*Input Decimal Position
Press the to change, then to
desired value, then press the .
Press the to change, then to
desired value, then press the .
T
O
T
A
L
I
Z
E
R
S
Tx TOTALIZER PRESET
-1 units
Selections
0 to 999999999
(*decimal position = 0)
9999.9999
(*decimal position = 4)
-1 = Off
Tx LOW FLOW CUTOFF
0 units
Selections
±
999999
(*decimal position = 0)
±
9.9999
(*decimal position = 4)