West Control Solutions MRC 9000 - Manual (Page 145)

Edition 3
Rev G
Section 4 4-63
4.1.8 TIMERS
Timers are seen only if the MATH option was specified and present in the model number order matrix.
From the Normal Display, press the until CONFIGURATION is seen in the lower display line. If PASS-
WORD appears in the lower display line, the correct "password" will need to be entered before access to Configu-
ration is allowed. If CONFIGURATION is not displayed, then Configuration has been disabled. Refer to Section 9,
Enables and Passwords, for instructions to enable Configuration.
With CONFIGURATION in the display, press the , then the until TIMERS appears in the lower display
line.
1. Press the to display TIMER NUMBER.
2. Press the to advance to the next parameter, DISPLAY TAG.
TIMER NUMBER
1
Selections
1 to 4
Press the to change, then to
desired number, then press the .
Refer to Section 3.4.2 Changing Text, page 3-3 for
instructions.
TMx DISPLAY TAG
TIMER X
Selections
Text
T
I
M
E
R
S