Tx copy / initialize no, Totalizer number 1 – West Control Solutions MRC 9000 User Manual
Page 136
Section 4
Edition 3
Rev G
4-54
4.1.7 TOTALIZERS
Totalizers are seen only if TOTALIZATION was specified and present in the model number order matrix.
From the Normal Display, press
the until CONFIGURATION is seen in the lower display line. If PASS-
WORD appears in the lower display line, the correct "password" will need to be entered before access to Configu-
ration is allowed. If CONFIGURATION is not displayed, then Configuration has been disabled. Refer to Section
9, Enables and Passwords, for instructions to enable Configuration.
With CONFIGURATION in the display, press the
, then the
until TOTALIZERS appears in the lower
display line.
1. Press the
to display TOTALIZER NUMBER.
2. Press the
to advance to the next parameter, COPY/INITIALIZE.
Choose YES if the parameter to be programmed are the same as another TOTALIZER already programmed.
Press the
to change, then
to
desired number, then press the
.
TOTALIZER NUMBER
1
Selections
1 to 4
Tx COPY / INITIALIZE
NO
Selections
NO YES
Press the
to change, then
to
desired choice, then press the
.
T
O
T
A
L
I
Z
E
R
S