West Control Solutions MRC 9000 - Manual (Page 186)

Edition 3
Rev G
Section 5 5-1
Section 5 - Display Programming
Selections made in the Display prompts section determine what is displayed and how it is displayed.
From the Normal Display, press the . If the Display prompts are disabled, when the DISP key is pressed,
DISPLAY KEY DISABLED will appear in the lower display line. Refer to Section 9, Enables and Passwords, for
instructions to enable Display prompts.
If the Display Prompts are not disabled BUT the password is other than zero, DISPLAY KEY PASSWORD will
appear in the display when the DISP key is pressed. If the correct "password" is entered, DISPLAY MODE will
appear in the upper display line. If the incorrect "password" is entered, INVALID PASSWORD will appear in the
upper display line.
If the Display Prompts are not disabled AND the password is set to zero, when the key is pressed, DISPLAY
MODE will appear in the upper display line.
For the prompts associated with the key, the unit automatically goes into the modify mode. For simplicity of
operation, use the Special keys below the display, referred to as F1 thru F5, for making choice selections. Upon
selection of a new choice/value, the unit will again automatically go into the modify mode.
In this prompt section, use the key to advance to the next prompt without modifying the current parameter.
1. If instrument is a Controller, the following prompts may appear up to (4) times, one for each CONTROL STATE
ACCESS (CA) configured in CONTROL STATE ACCESS section of CONFIGURATION. The prompts are visible
for CAx if CAx LINE 1 TEXT is not blank. In the description of these prompts, x is the CA number, 1-4, and, if the
defaults are not changed, the controller number.
t t t t t t t t t t t t t t t t t t t t default "CONTROLLER x STATES"
vvvvvvvvvvvvvvvvvvvv Automatic Modify Mode (AMM) used, default "A/M SP1/SP2 L/R"
The "t t" field is the configured CAx LINE 1 TEXT and the "v v" field is the configured CAx LINE 2 TEXT. Note that
although AMM is in use, none of the fields in this prompt are modifiable, and none will be flashing.
2. When the above prompt is displayed, if any function keys for CAx have usage other than NOT USED, pressing
that key will display the following:
t t t t t t t t t t t t t t t t t t t t default "CONTROLLER x STATE"
(CC) AMM used
The "t t" field is the configured CAx Fn LINE 1 TEXT, where "n" is the function key number, 1-5. The "cc" field is a
two item choice which causes the CAxFn actuator to be cleared (left choice) or set (right choice). The choice text
will be as configured if the usage is CUSTOM, otherwise it will be one of AUTOMATIC/MANUAL, SP1/SP2 or
LOCAL/REMOTE.