Process value number 1, Pvx copy / initialize no – West Control Solutions MRC 9000 User Manual
Page 114
Section 4
Edition 3
Rev G
4-32
4.1.5 PROCESS VARIABLES
Process Variables define variables for use with alarms and/or control outputs
From the Normal Display, press the
until CONFIGURATION is seen in the lower display line. If PASS-
WORD appears in the lower display line, the correct "password" will need to be entered before access to Configu-
ration is allowed. If CONFIGURATION is not displayed, then Configuration has been disabled. Refer to Section
9, Enables and Passwords, for instructions to enable Configuration.
With CONFIGURATION in the display, press the
, then the
until PROCESS VARIABLES appears in
the lower display line.
1. Press the
to display PROCESS VALUE NUMBER.
2. Press the
to advance to the next parameter, COPY/INITIALIZE.
Select YES if the parameters to be programmed are the same as another PROCESS VARIABLE already pro-
grammed.
Press the
to change, then
to
desired number, then press the
.
Press the
to change, then
to
desired choice, then press the
.
PVx COPY / INITIALIZE
NO
Selections
NO or YES
P
R
O
C
E
S
S
V
A
R
I
A
B
L
E
S
PROCESS VALUE NUMBER
1
Selections
1 to 4