West Control Solutions MRC 9000 - Manual (Page 49)

Edition 3
Rev G
Section 3 3-13
MAIN PROMPTS
CONFIGURATION
CHART
PROMPTS
CHANGE
CHART
START
CHART
CHART
ROTATE
TREND
COLLECT
CHART
SPEED CHART
CONFIG
YES
NO
DISP
PROMPTS
DISP
PASSWORD
SYSTEM
PROMPTS
SYSTEM
PASSWORD
ACT/TIME
SETTINGS
ALARM
SETTINGS
ENABLES
PASSWORDS
CONFIG. TEST CAL MODEL
REV
TUNING
PARAMETERS*
* CONTROLLER ONLY
DISP
MODE
DISP
FORMAT
SEQ DISP
DURATION
OPER
INPUT
CHART
PASSWORD
CONTROLLER
STATE ACCESS*
SELECT
SETPOINTS*
SELECT
MANUAL VALUES*
3.9 GETTING STARTED
Before attempting any configuration/programming, review Sections 3.3 Keypad Function; 3.4 Changing Param-
eter Settings; 3.7 Display Details; 3.8 Chart Details; and Appendix C Reference Section.
Then, using the Flow Charts below, the Quick Start Procedure, page 3-14 and filled in the Software Reference/
Record Sheets, determine the prompts and parameters that will be required for proper operation of the instru-
ment and begin the configuration and programming procedures as described in Section 4 Configuration; Section
5 Display Programming; Section 6 Chart Prompts, and if required, Section 7 Alarm Settings and Section 8 Action
Time Settings. Section 9 contains procedures for Enabling/Disabling and entering Passwords.
Appendix D may be referred to for examples of how to program/configure some prompts and parameters.
CONFIG INPUTS CONSTANTS CUSTOM
CURVES
DERIVED
VARIABLES
TIMERS LEDS RELAYS
CURRENT
OUTPUTS INSTRUMENT
SETTINGS
DERIVED
ACTUATORS
OPERATOR
INPUTS
OPERATOR
MESSAGES
CHART
MESSAGES
PROCESS
VARIABLES RECORDERS TOTALIZERS CONTROLLERS* SETPOINTS*
SIMULATED
VARIABLES
CONTROL STATE
ACCESS*
* CONTROLLER ONLY