West Control Solutions MRC 9000 - Manual (Page 253)

Section 13 Edition 3
Rev G 13-22
13.3 CONTROL STATE ACCESS
CONTROL STATE ACCESS provides a quick and convenient method for changing states, such as AUTO to
MANUAL or LOCAL to REMOTE setpoint. If configured, when the key is pressed, a two line prompt is
displayed and the Function Keys, as configured, perform these change state requirements. The two line prompt
which appears is fully configurable via the CONTROL STATE ACCESS section of CONFIGURATION.
From the Normal Display, press the key until CONFIGURATION is seen in the lower display line. If PASS-
WORD appears in the lower display line, the correct “password” will need to be entered before access to CON-
FIGURATION is allowed. If CONFIGURATION is not displayed, then Configuration has been disabled. Refer to
Section 9, Enables and Passwords, for instructions to enable Configuration.
With CONFIGURATION in the lower display line, press the key, then the key until CONTROL STATE
ACCESS appears in the lower display line. Press the key to display CONTROL STATE ACCESS on the
upper display line.
1. Press the and LINE 1 TEXT appears in the upper display line and CONTROLLER x STATES appears in
the lower display line. This prompt defines the text that will appear in the upper display line when the key is
pressed while in the Normal Display.
CA1 LINE TEXT
CONTROLLER x
Selections
TEXT
NOTE: If the CONTROL STATE ACCESS is not being used for Controller 1, it is suggested that this prompt be
blank.
Refer to Section 3.4.2, Changing Text,
for instructions .