Derived actuator 1 – West Control Solutions MRC 9000 User Manual

Page 164

Section 4

Edition 3
Rev G

4-82

DERIVED ACTUATOR

Selections

1 to 24

Press the

to change, then

desired number, then press the

17. Press the

and the display advances to INSTRUMENT TAG. To exit, press the

. Refer to the

beginning of this section, page 4-72.

4.1.13 DERIVED ACTUATORS

Derived Actuators are used when two or more actuators need to be combined logically.

From the Normal Display, press the

until CONFIGURATION is seen in the lower display line. If PASSWORD

appears in the lower display line, the correct "password" will need to be entered before access to Configuration is

allowed. If CONFIGURATION is not displayed, then Configuration has been disabled. Refer to Section 9, En-

ables and Passwords, for instructions to enable Configuration.

With CONFIGURATION in the display, press the

, then the

until DERIVED ACTUATORS appears in

the lower display line.

1. Press the

to display DERIVED ACTUATOR.