Relay number 1, Relay x usage state or on - off – West Control Solutions MRC 9000 User Manual
Page 150
Section 4
Edition 3
Rev G
4-68
L
E
D
S
&
R
E
L
A
Y
S
4.1.10 RELAYS
Relays only available when specified and present in the model number order matrix.
From the Normal Display, press the
until CONFIGURATION is seen in the lower display line. If PASS-
WORDS appears in the lower display line, the correct "password" will need to be entered before access to Con-
figuration is allowed. If CONFIGURATION is not displayed, then Configuruation has been disabled. Refer to
SEction 9, Enables and Passwords, for instructions to enable Configuration.
With CONFIGURATION in the display, press the
, then the
until RELAYS appears in the lower display
line.
1. Press the
to display RELAY NUMBER.
2. Press the
to advance to the next parameter, RELAY USAGE.
RELAY NUMBER
1
Selections
1 to 8
Press the
to change, then
to
desired number, then press the
.
Press the
to change, then
to
desired choice, then press the
.
RELAY x USAGE
STATE OR ON - OFF
Selections
STATE OR ON-OFF
PULSED OUTPUT
TIME PROPORTIONING