West Control Solutions MRC 9000 User Manual

Page 167

Edition 3

Rev G

Section 4

4-85

4. Press the

and the display advances to the next derived actuator to be programmed. Refer to the

beginning of this section, page 4-80.

4.1.14 OPERATOR INPUTS

Operator Inputs are prompts programmed that allow these prompts to turn on or off actuators that control some

other function within the instrument.

From the Normal Display, press the

until CONFIGURATION is seen in the lower display line. If PASS-

WORD appears in the lower display line, the correct "password" will need to be entered before access to Configu-

ration is allowed. If CONFIGURATION is not displayed, then Configuration has been disabled. Refer to Section 9,

Enables and Passwords, for instructions to enable Configuration.

With CONFIGURATION in the display, press the

, then the

until OPERATOR INPUTS appears in the

lower display line.

1. Press the

to display OPERATOR INPUT.

2. Press the

to advance to the next parameter, COPY/INITIALIZE.

V
E

A
C

U
A

P
E

R
A

OPERATOR INPUT

Selections

1 to 12

Press the

to change, then

desired number, then press the

Press the

to change, then

desired choice, then press the

OIxx COPY / INITIALIZE

Selections

NO YES