Spx prompt text setpoint 1, Spx display units ° f, Spx other units ° f – West Control Solutions MRC 9000 User Manual

Page 250

Edition 3

Rev G

Section 13

13-19

2. Press the

to advance to the next parameter, PROMPT TEXT.

SPx PROMPT TEXT

SETPOINT 1

Selections

TEXT

Note: If PROMPT TEXT is blank, the corresponding setpoint will not be activated or appear in the prompts associ-

ated with the

key. Also, no other prompts are displayed for configuring the setpoint.

3. Press the

to advance to the next parameter, DISPLAY UNITS.

SPx DISPLAY UNITS

Selections

F OTHER

4. If DISPLAY UNITS selected was OTHER, press the

to advance to the next parameter, OTHER UNITS.

SPx OTHER UNITS

Selections

TEXT

Press the

to change, then

to desired

choice, then press the

, or press the key directly

below the desired choice.

Refer to Section 3.4.2, Changing Text, for instructions.