West Control Solutions MRC 9000 - Manual (Page 268)

Edition 3
Rev G
Section 13 13-37
12.Press the to advance to the next parameter, OUTPUT 1 RATE (only if output 1 is proportional).
Cx OUT 1 RATE
0.00 MINUTES
Selections
0 to 100.00
13.Press the to advance to the next parameter, OUTPUT 2 RATE (only if output 2 is proportional).
Cx OUT 2 RATE
0.00 MINUTES
Selections
0 to 100.00
RATE attempts to anticipate rapid changes in system response and compensates before overshoot occurs. Rate
can be applied at anytime, unlike auto reset which occurs within the integration band. The value is defined in
minutes.
14.Press the and the display advances to the next controller to be tuned. Refer to the beginning of this
section, page 13-31 .
Press the to change, then or
to desired number, then press the .
Press the to change, then or
to desired number, then press the .