Recorder number 1, Rx copy / initialize no – West Control Solutions MRC 9000 User Manual
Page 127
Edition 3
Rev G
Section 4
4-45
4.1.6 RECORDERS
Recorders defines values being recorded, tags, method, source of data and chart divisions and zoning.
In the Normal Display, press the
until CONFIGURATION is seen in the lower display line. If PASSWORD
appears in the lower display line, the correct "password" will need to be entered before access to Configuration is
allowed. If CONFIGURATION is not displayed, then Configuration has been disabled. Refer to Section 9,
Enables and Passwords, for instructions to enable Configuration.
With CONFIGURATION in the display, press the
, then the
until RECORDERS appears in the lower
display line.
1. Press the
to display RECORDER NUMBER.
2. Press the
to advance to the next parameter, COPY/INITIALIZE.
Choose YES if the parameters to be programmed are the same as another RECORDER already programmed.
R
E
C
O
R
D
E
R
S
Press the
to change, then
to
desired number, then press the
.
RECORDER NUMBER
1
Selections
1 to 4
Press the
to change, then
to
desired choice, then press the
.
Rx COPY / INITIALIZE
NO
Selections
NO YES