West Control Solutions MRC 9000 - Manual (Page 249)

Section 13 Edition 3
Rev G 13-18
13.2 CONTROL SETPOINTS
There are 8 Control Setpoints that can be configured in the SETPOINTS section of CONFIGURATION. This
menu sets the text prompt for the setpoint, the unit type, decimal position, limits and the display option mode.
Setting and/or changing the setpoints is accomplished via the prompt section.
If the PROMPT TEXT description for the setpoint is blank, the setpoint IS NOT ACTIVE and WILL NOT BE
DISPLAYED in the prompt section.
From the Normal Display, press the key until CONFIGURATION is seen in the lower display line. If PASS-
WORD appears in the lower display line, the correct “password” will need to be entered before access to CON-
FIGURATION is allowed. If CONFIGURATION is not displayed, then Configuration has been disabled. Refer to
Section9, Enables and Passwords, for instructions to enable Configuration.
With CONFIGURATION in the lower display line, press the key, then the key until SETPOINTS
appears in the lower display line.
1. Press the key to display SETPOINT NUMBER.
SETPOINT NUMBER
1
Selections
1-8
Press the to change, then ,
to desired setpoint number, then
press the .