West Control Solutions MRC 9000 - Manual (Page 209)

Edition 3
Rev G
Section 9 9-1
Section 9 - Enables & Passwords
Enables and Passwords provides a means of enabling or disabling prompt sections and provides additional
operational security with the use of 6 digit password.
If the Display prompts or Chart prompts are disabled, those prompt sections will not be accessible and DISPLAY
KEY DISABLED or CHART KEY DISABLED will be displayed when the corresponding key is pressed. If other
prompt sections are disabled, their corresponding access or selection prompts will not appear.
Passwords can restrict access to the Display, Chart, and System prompts, and the Enables and Passwords
prompts section. If any of the passwords is set to a value other than zero, the corresponding password will be
requested when the operator attempts to access that prompt section. Should a password be forgotten or mis-
placed, contact the factory for the master password.
From the Normal Display, press the until ENABLES & PASSWORDS appears in the lower display line. If
PASSWORD appears in the lower display line, the correct "password" will need to be entered before access to
Enables & Passwords is allowed.
1. Press the to display CHANGE ALL ENABLES.
Choose YES to change all Enables at the same time.
If selection was NO, proceed to step 2.
If selection was YES:
CHANGE ALL ENABLES
NO
Selections
NO YES
Press the to change, then , to
desired choice, then press the .
Press the to change, then ,
to desired choice, then press
t h e .
CHANGE ALL TO
TOGGLE
Selections
DISABLED ENABLED
TOGGLE