West Control Solutions Pro-16 - Manual (Page 62)

Programmer
9499-040-93811 / 59537-1 Page 62 of 88 Pro-16
8.1.1 Programmer display
Programmer is in reset and the internal controller set-
point is effective. Segment or program number and
OFF are displayed (configurable with BlueControl:
Configuration
r Other r PDis3).
Programmer running (run LED is lit). Segment or
program number, segment type (
/ rising; \ falling;
- hold) and program/segment rest time or runtime
are displayed (configurable with BlueControl:
Configuration
r Other r PDis3).
Program end was reached. The set-point defined in
the last segment is effective. Segment or program
number and
End are displayed (configurable with
BlueControl: Configuration r Other r PDis3).
Function key è was used to switch over to the
controller. The instantaneously effective correcting
variable is displayed.
8.1.2 Segment type
Ramp-
segment
(time) With a ramp segment (time), the set-point runs
linearly from the start value (end of previous
segment) towards the target set-point (Sp) of the
relevant segment during time Pt (segment
duration).
Ramp-
segment
(gradient) With a ramp segment (gradient), the set-point
runs linearly from the start value (end value of
previous segment) towards the target value (Sp)
of the relevant segment. The gradient is
determined by parameter Pt.
Hold
segment With a hold segment, the end set-point of the
previous segment is output constantly during a
defined time which is determined by parameter
Pt.
Step
segment With a step segment, the program set-point
goes directly to the value specified in parameter
Sp. With configured control deviation alarms,
the alarm is suppressed within band monitoring.