West Control Solutions Pro-16 - Manual (Page 4)

9499-040-93811 / 59537-1 Page 4 of 88 Pro-16
4.4 Configuration examples 46
4.4.1 On-Off controller / Signaller (inverse) 46
4.4.2 2-point and continuous controller (inverse) 47
4.4.3 3-point and continuous controller 48
4.4.4 3-point stepping controller (relay & relay) 49
4.4.5 - Y - Off controller / 2-point controller with pre-contact 50
4.4.6 KS 20-1 with measured value output 51
5. Parameter-Level 52
5.1 Parameter-Overview 52
5.2 Parameter 53
6. Input scaling 57
7. Calibration level 58
8. Programmer 61
8.1 Operation 61
8.1.1 Programmer display 62
8.1.2 Segment type 62
8.1.3 Bandwidth monitoring 63
8.1.4 Search run at programmer start 64
8.1.5 Behaviour after mains recovery or sensor error 64
8.2 Parameter overview 65
8.3 Parameter 66
8.4 Programmer description 68
8.4.1 General 68
8.4.2 Programmer set-up: 69
9. Special functions 71
9.1 Start-up circuit 71
9.2 Boost function 72
9.3 KS 20-1 as Modbus-Master 73
9.4 Linearization 74
9.5 Timer 75
9.5.1 Setting up the timer 75
9.5.2 Determining the timer run-time 76
9.5.3 Starting the timer 77
10. Ordering information 78
11. BlueControl ® 79
11.1 Configuration Port 80