KROHNE OPTISONIC 7300 EN - Manual (Page 93)

TECHNICAL DATA
8
93
OPTISONIC 7300
www.krohne.com 09/2012 - 4001102303 - MA OPTISONIC 7300 R03 en
Pressure Pressure Pressure Pressure
All sensor designs at full rating acc. to below flange standards for standard
materials.
Max. pressure limited by
transducer
Titanium S7.01: 150 bara
Titanium S7.04: 101 bara
EN 1092-1 DN200…600: PN 10
DN100…150: PN 16
DN50...80: PN 40
ASME B16.5 2…24”: 150 lb RF
2…24”: 300 lb RF
2…24”: 600 lb RF
2...14": 900 lb RF
Higher pressure ratings on request
Properties of medium Properties of medium Properties of medium Properties of medium (Other properties on request)
Physical condition Dry gas
Density Standard Standard Standard Standard
10…45 g/mol / 1...150 kg/m 3 / 0.062...9.36 lb/ft 3
Extended Extended Extended Extended (may impose limitations on other spec's)
2…80 g/mol / 0.2...250 kg/m 3 / 0.012...15.6 lb/ft 3
Installation conditions
Installation For detailed information refer to Installation on page 16.
Inlet run ≤DN80: ≥ 20 DN
≥DN100: ≥ 10 DN
Outlet run ≥ 3 DN
Dimensions and weights For detailed information refer to Dimensions and weights on page 102.
Materials
Sensor Sensor Sensor Sensor
NACE conformity For standard range, all wetted materials are conform NACE MR175/103.
Flanges
(wetted)
Standard: carbon steel ASTM A105 N
Option: stainless steel 316 L, Carbon steel A350 LF2
Other materials on request.
Tube
(wetted)
Standard: carbon steel ASTM A106 Gr. B or Equivalent
Option: stainless steel 316 L, Carbon steel A333 GR6
Other materials on request.
Nozzles transducer
holders (wetted)
Stainless steel 316 Ti (1.4571)
Transducer holders
(wetted)
Stainless steel 316 L (1.4404)
Transducers (wetted) Titanium grade 29
Transducer o-rings
(wetted)
Standard: FKM / FPM
Option: FFKM
Coating Polyurethane