KROHNE OPTISONIC 7300 EN - Manual (Page 81)

OPERATION
6
81
OPTISONIC 7300
www.krohne.com 09/2012 - 4001102303 - MA OPTISONIC 7300 R03 en
C5.6.3 load settings Load saved settings.
Select: cancel (exit function without loading) / factory settings (load in
state as delivered) / backup 1 (load data from storage location 1) /
backup 2 (load data from storage location 2) / load sensor data (factory
settings of calibration data)
Query: go on with copy? (can not be undone)
Select: no (exit the function without saving) / yes (load data from the
selected storage location)
C5.6.4 password quick set Password required to change data in the quick setup menu.
xxxx (password required)
Range 4 digits: 0001…9999
0000 (= to quick setup menu without password)
C5.6.5 password setup Password required to change data in the setup menu.
0000 (= to quick setup menu without password)
xxxx (password required); range 4 digits: 0001…9999
C5.6.6 GDC IR interface This function requires an optical GDC adapter connected to the LCD
display.
Break (exit function without connection)
Activate (Interrupts the optical keys)
After 60 seconds pass without a connection being established or after
the adapter is removed, the function is exited and the optical keys are
active again.
C5.7 units
C5.7.1 size mm; inch
C5.7.2 volume flow
m 3 /d; m 3 /h; m 3 /min; m 3 /s; l/h; l/min; l/s (l = litres); ext. unit selection
(activates option for more units, sequence see below); cf/d; cf/h; cf/m;
cf/s
C5.7.3 ext. unit selection Active if “ext. unit selection” is selected in C5.7.2.
MMcf/d; Mcf/d; MMcf/h; Mcf/h; free unit (set factor and text in the next
two functions, sequence see below)
C5.7.4 text free unit Active if "free unit" is selected in C5.7.3.
For text to be specified refer to Set free units on page 83.
C5.7.5
[m
3
/s]*factor Specification of the conversion factor, based on m
3
/s.
For information refer to Set free units on page 83.
C5.7.6 corr. volume flow
MMscf/d; Mscf/d; MMscf/h; Mscf/h; scf/d; scf/h; scf/m; scf/s; Nm
3
/d;
Nm 3 /h; free unit (set factor and text in the next two functions,
sequence see below)
C5.7.7 text free unit Active if "free unit" is selected in C5.7.6.
For text to be specified refer to Set free units on page 83.
C5.7.8 [Normal
m
3 /s]*factor
Specification of the conversion factor, based on normal m 3 /s.
For information refer to Set free units on page 83.
C5.7.9 mass flow lb/h; lb/s; t/h; kg/h; kg/s; free unit (set factor and text in the next two
functions, sequence see below)
C5.7.10 text free unit Active if "free unit" is selected in C5.7.9.
For text to be specified refer to Set free units on page 83.
C5.7.11 [kg/s]*factor Specification of the conversion factor, based on kg/s.
For information refer to Set free units on page 83.
C5.7.15 velocity m/s; ft/s