Brocade FastIron SX Series Chassis Hardware Installation Guide - Manual (Page 55)

DANGER
Make sure the rack or cabinet housing the device is adequately secured to prevent it from
becoming unstable or falling over.
DANGER
Mount the devices you install in a rack or cabinet as low as possible. Place the heaviest device
at the bottom and progressively place lighter devices above.
Power precautions and warnings
DANGER
The power supplies are hot swappable, which means they can be removed and replaced while
the chassis is powered on and running. However, Brocade recommends that you disconnect the
power supply from the wall outlet before removing and replacing the supply. The device can be
running while a power supply is being installed or removed, but the power supply itself should
not be connected to a power source. Otherwise, you could be injured or the power supply or
other parts of the device could be damaged.
DANGER
If the installation requires a different power cord than the one supplied with the device, make
sure you use a power cord displaying the mark of the safety agency that defines the regulations
for power cords in your country. The mark is your assurance that the power cord can be used
safely with the device.
DANGER
Make sure to choose the appropriate circuit device depending on the number of AC power
supplies installed in the chassis. The minimum current draw for the system is one AC power
supply.
DANGER
Make sure that the power source circuits are properly grounded, then use the power cord
supplied with the device to connect it to the power source.
DANGER
Disconnect the power cord from all power sources to completely remove power from the device.
Power precautions and warnings
Brocade FastIron SX Series Chassis Hardware Installation Guide 53
53-1003092-01