Brocade FastIron SX Series Chassis Hardware Installation Guide - Manual (Page 34)

mode (full-duplex or half-duplex) of the port at the other end of the link, and adjust the port
accordingly. Ports running at 1000 Mbps operate in full-duplex mode only and cannot be modified.
The 24-port Gigabit Ethernet copper interface module supports Power over Ethernet (PoE). You can
either order the interface module with PoE capability, or upgrade your existing 24-port Gigabit Ethernet
Copper module by installing a PoE daughter card. To run PoE on your system, you must also install at
least one 48-volt power supply.
FIGURE 9 Second Generation 24-port Gigabit Ethernet copper module front panel
1. Port 1 13. Port 13
2. Port 2 14. Port 14
3. Location of LEDs 24. Port 24
The front panel includes the following control features:
• 24 10/100/1000 copper ports
• 24 LEDs for port status
• 24 LEDs for PoE status
NOTE
The PoE LEDs work only when PoE is enabled on your device.
LEDs for 24-port copper module
The front panel of the 24-port Gigabit Ethernet copper module includes 24 LEDs (top) that indicate the
status of each port, and 24 LEDs (bottom) that indicate the PoE status.
NOTE
The PoE LEDs work only when PoE is enabled on your device.
Hardware features
32 Brocade FastIron SX Series Chassis Hardware Installation Guide
53-1003092-01