Brocade FastIron SX Series Chassis Hardware Installation Guide - Manual (Page 53)

Installing FastIron SX Devices
● Unpacking the system.....................................................................................................51
● Installation precautions................................................................................................... 52
● Preparing the installation site.......................................................................................... 55
● Removing extra shipment screws (FSX 800 only).......................................................... 56
● Installing the chassis in a rack........................................................................................ 56
● Removing the slot panels................................................................................................59
● Installing management and interface modules................................................................60
● Attaching a management station.....................................................................................66
● Powering on the system..................................................................................................67
● Verifying proper operation...............................................................................................73
This chapter describes how to install your FastIron SX devices.
DANGER
The procedures in this manual are for qualified service personnel.
NOTE
Information about configuring IP addresses and connecting a FastIron SX chassis device to other
network devices is covered in the “Connecting Network Devices and Checking Connectivity” section.
Unpacking the system
FastIron SX devices ship with the following items. Review this list and verify the contents:
NOTE
If any items are missing, contact the place of purchase.
• FastIron SX chassis with the following components installed:
‐ One or two 12-volt power supplies
‐ Fan tray assembly or assemblies
‐ Slot panels installed in all unoccupied slots
‐ Two switch fabric modules installed
• Rack Mount Kit (FSX 1600 models only)
• Management module or modules (packaged separately)
• Optional interface modules (packaged separately)
• Warranty card
• A 115V AC power cable for each AC power supply you purchase from Brocade
Brocade FastIron SX Series Chassis Hardware Installation Guide 51
53-1003092-01