Switch fabric module leds, Interface modules – Brocade FastIron SX Series Chassis Hardware Installation Guide User Manual
Page 30
on page 27 shows an FSX 800 and FSX 1600 switch fabric module front panel.
FIGURE 7 FSX 800 and FSX 1600 switch fabric module front panel
Switch fabric module LEDs
The front panel provides status information through the LEDs listed in the table below.
Switch fabric module LEDs
TABLE 6
LED
Description and Position
State
Meaning
Pwr
Top LED
On (Green)
The module is receiving power.
Off
The module is not receiving power.
Active
Bottom LED
On (Green)
The module is functioning properly.
Off
The module is not functioning properly.
Interface modules
This section describes interface modules for the FastIron X Series chassis devices. The following
installation rules apply:
•
In the FSX 800 device, you can install up to eight single slot and four double interface modules in
the slots shown in
on page 19.
•
In the FSX 1600 device, you can install up to 16 single slot and eight double slot interface
modules in the slots shown in
NOTE
You cannot mix Second Generation and Third Generation modules in the same device.
The table below lists the supported interface modules for each FastIron X Series chassis device type.
Interface modules
TABLE 7
Interface Module
Part Number
FSX 800
FSX 1600
Second Generation Interface Modules
24-port Gigabit Ethernet copper without PoE
SX-FI624C
X
X
24-port Gigabit Ethernet copper with PoE
SX-FI624P
X
X
Switch fabric module LEDs
28
Brocade FastIron SX Series Chassis Hardware Installation Guide
53-1003092-01