Brocade FastIron SX Series Chassis Hardware Installation Guide - Manual (Page 25)

You can install the following components in the slots:
• Up to two management modules
• Up to 16 single slot and up to 8 double slot interface modules
• Up to eight AC or DC power supplies (four system (SYS) power supplies and four PoE power
supplies)
Before installing any modules or power supplies, you must remove the slot panel.
CAUTION
If you do not install a module in a slot, you must keep the slot panel in place. If you run the
chassis with an uncovered slot, the system will overheat.
The figure below identifies the slots where you can install modules and power supplies, and the
electrostatic discharge (ESD) connector, into which you can plug an ESD wrist strap to ground yourself
while handling and installing modules.
1 Interface slot 1
2 Interface slot 2
3 Interface slot 3
4 Interface slot 4
5 interface slot 5
6 Interface slot 6
7 Interface slot 7
8 Interface slot 8
9 Interface slot 9
10 Interface slot 10
11 Interface slot 11
12 Interface slot 12
13 Interface slot 13
14 Interface slot 14
Hardware features
Brocade FastIron SX Series Chassis Hardware Installation Guide 23
53-1003092-01