Brocade FastIron SX Series Chassis Hardware Installation Guide - Manual (Page 29)

FSX 800 and FSX 1600 management module LEDs (Continued) TABLE 5
LED Description and Position State Meaning
Off The module is not the active management
module.
10/100/1000 Copper Port LEDs on SX-FI-ZMR-XL and SX-FI-ZMR-XL-PREM6 modules only
MGMT-Link Right-most LED above the port On (Green) 10/100/1000
Blinking The port is transmitting and receiving traffic.
Off No port connection exists.
Sync-Link Left-most LED above the port On (Green) Two management modules are present.
Blinking Active and Standby modules are syncing.
Off No port connection exists.
SFP+ port LEDs on SX-FI-2XGMR-XL and SX-FI-2XGMR-XL-PREM management modules only
Port 1 Left SFP+ On (Green) The SFP+ port is linked.
Blinking The SFP+ port has TX/RX activity.
Off The SFP+ port is not linked.
Port 2 Right SFP+ On (Green) The SFP+ port is linked.
Blinking The SFP+ port has TX/RX activity.
Off The SFP+ port is not linked.
Console port
The Console port on SX-FI-ZMR-XL and SX-FI-ZMR-XL-PREM6 management modules and the SX-
FI-2XGMR-XL and SX-FI-2XGMR-XL-PREM management modules has an RJ45 connector.
The Console port interfaces with the control plane only and does not interface with the data plane.
Reset button
The SX-FI-ZMR-XL and SX-FI-ZMR-XL-PREM6 management modules and the SX-FI-2XGMR-XL and
SX-FI-2XGMR-XL-PREM management modules do not have a reset button.
Switch fabric modules
Switch fabric modules switch user packets from one interface module to another. Switch fabric modules
in the FSX 800 and FSX 1600 devices are separate and are located next to the management modules
in the device.
Switch fabric modules
Brocade FastIron SX Series Chassis Hardware Installation Guide 27
53-1003092-01