Brocade Multi-Service IronWare Security Configuration Guide (Supporting R05.6.00) - Manual (Page 341)

Multi-Service IronWare Security Configuration Guide 323
53-1003035-02
Sample 802.1x configurations
8
Syntax: show dot1x mac-session brief [ | begin expression | exclude expression | include
expression]
The following table describes the information displayed by the show dot1x mac-session brief
command.
Sample 802.1x configurations
This section illustrates a sample point-to-point configuration and a sample hub configuration that
use 802.1x port security.
Point-to-point configuration
Figure 7 illustrates a sample 802.1x configuration with clients connected to three ports on the
device. In a point-to-point configuration, only one 802.1x client can be connected to each port.
FIGURE 7 Sample point-to-point 802.1x configuration
TABLE 53 Output from the show dot1x mac-session brief command
This field... Displays...
Port Information about the users connected to each port.
Number of users The number of restricted and authorized (those that were successfully
authenticated) users connected to the port.
Dynamic VLAN Whether or not the port is a member of a RADIUS-specified VLAN.
Dynamic ACL Whether or not a RADIUS-specified ACL has been applied to the port for
incoming (in) and outgoing (out) traffic.
Dynamic MAC Filters Whether or not a RADIUS-specified MAC Filter has been applied to the port.
Brocade# show dot1x mac-session brief
Port Number of users Dynamic Dynamic Dynamic
Restricted Authorized Total VLAN ACL (In/Out)MAC-Filt
---------+----------+----------+-----+-------+-----------+--------
1/1 0 0 1 no no/no no
1/2 0 1 1 yes yes/no no
1/3 0 1 1 yes yes/no no
1/4 0 1 1 yes yes/no no
1/5 0 1 1 yes yes/no no