Brocade Multi-Service IronWare Security Configuration Guide (Supporting R05.6.00) - Manual (Page 233)

Multi-Service IronWare Security Configuration Guide 215
53-1003035-02
ACL accounting
4
Displaying statistics for IPv6 ACL accounting
To display statistics for IPv6 accounting, enter commands such as the following.
Table 30 describes the output parameters of the show ipv6 access-list accounting brief command.
Syntax: show ipv6 access-list accounting brief
Displaying IPv6 accounting statistics for an interface
To display statistics for an interface, enter commands such as the following.
TABLE 30 Output of the show ipv6 access-list accounting brief command
Field Description
Collecting IPv6 ACL accounting
summary for interface Shows the interface for which the ACL accounting summary is collected and
specifies whether or not the collection is successful.
Int Shows the ID of the interface for which the statistics are being reported.
In ACL Shows the ID of the ACL used to filter the incoming traffic on the interface.
Total In Hit a
a. The Total In Hit and Total Out Hit display the total number of hits for all the ACL entries (or filters) in an ACL. For
example, if an ACL has five entries and each entry processed matching conditions three times during the last
minute, then the total Hits for the 1m counter is 15.
Shows the number of hits from the incoming traffic processed by all the ACL
entries (filters) in the ACL.
Out ACL Shows the ID of the ACL used to filter the outgoing traffic on the interface.
Total Out Hit 1 Shows the number of hits from the outgoing traffic processed by all the ACL
entries (filters) in the ACL.
Brocade# show ipv6 access-list accounting brief
Collecting IPv6 ACL accounting summary for 1/26 ... Completed successfully.
Collecting IPv6 ACL accounting summary for 1/25 ... Completed successfully.
Int In ACL Total In Hit Out ACL Total Out Hit
1/26 ipv6-port2 450375(1s)
27009259(1m)
135046361(5m)
464353218(ac)
1/25 ipv6-port 2234540(1s)
11321736(1m)
0(5m)
11321736(ac)
Brocade# show ipv6 access-list accounting ethernet 1/24 out
IPv6 ACL ipv6-protocol-ahp-deny-test-66
Collecting IPv6 ACL accounting for 1/24 ... Completed successfully.
10: deny enable-accounting ahp any host 3002::10
Hit count: (1 sec) 2 (1 min) 15
(5 min) 92 (accum) 107