Brocade Multi-Service IronWare Security Configuration Guide (Supporting R05.6.00) User Manual
Page 131
Multi-Service IronWare Security Configuration Guide
113
53-1003035-02
Configuring numbered and named ACLs
3
precedence name
| num
The precedence option for of an IP packet is set in a three-bit field following
the four-bit header-length field of the packet’s header.
NOTE
This parameter is not supported on Brocade NetIron CES or Brocade NetIron
CER devices.
You can specify one of the following name or number:
•
critical or 5 – The ACL matches packets that have the critical
precedence. If you specify the option number instead of the name,
specify number 5.
•
flash or 3 – The ACL matches packets that have the flash precedence. If
you specify the option number instead of the name, specify number 3.
•
flash-override or 4 – The ACL matches packets that have the flash
override precedence. If you specify the option number instead of the
name, specify number 4.
•
immediate or 2 – The ACL matches packets that have the immediate
precedence. If you specify the option number instead of the name,
specify number 2.
•
internet or 6 – The ACL matches packets that have the internetwork
control precedence. If you specify the option number instead of the
name, specify number 6.
•
network or 7 – The ACL matches packets that have the network control
precedence. If you specify the option number instead of the name,
specify number 7.
•
priority or 1 – The ACL matches packets that have the priority
precedence. If you specify the option number instead of the name,
specify number 1.
•
routine or 0 – The ACL matches packets that have the routine
precedence. If you specify the option number instead of the name,
specify number 0.