Brocade Multi-Service IronWare Security Configuration Guide (Supporting R05.6.00) - Manual (Page 335)

Multi-Service IronWare Security Configuration Guide 317
53-1003035-02
Displaying 802.1x information
8
To display information about the 802.1x configuration on an individual port, enter a command such
as the following.
Syntax: show dot1x config ethernet slot/port
The following additional information is displayed in the show dot1x config command for an
interface.
Mac Session max-age The configured software aging time for dot1x-mac-sessions.
Maximum Failed Attempts The number of failed authentication attempts, if the authentication-failure
action shows Restricted VLAN,
TABLE 50 Output from the show dot1x config command for an interface
This field... Displays...
AuthControlledPortControl The port control type configured for the interface. If set to auto, authentication
is activated on the 802.1x-enabled interface.
multiple-hosts Whether the port is configured to allow multiple Supplicants accessing the
interface on the device through a hub.
Refer to
“Allowing multiple 802.1x clients to authenticate” for information on
how to change this setting.
max-clients The maximum number of clients that can be authenticated on this interface.
multiple-clients Shows if the interface is enabled or disabled for multiple client authentication.
filter-strict-security Shows if the interface is enabled or disabled for strict security mode.
TABLE 49 Output from the show dot1x command (Continued)
This field... Displays...
Brocade# show dot1x config e 1/3
Port 1/3 Configuration:
AuthControlledPortControl : Auto
max-clients : 32
multiple-clients : Enable
filter-strict-security : Enable