Brocade Multi-Service IronWare Security Configuration Guide (Supporting R05.6.00) - Manual (Page 338)

320 Multi-Service IronWare Security Configuration Guide
53-1003035-02
Displaying 802.1x information
8
Displaying dynamically assigned VLAN information
The show interface command displays the VLAN to which an 802.1x-enabled port has been
dynamically assigned, as well as the port from which it was moved (that is, the port’s default VLAN).
The following is an example of the show interface command indicating the port’s dynamically
assigned VLAN. Information about the dynamically assigned VLAN is shown in bold type.
In this example, the 802.1x-enabled port has been moved from VLAN 1 to VLAN 4094. When the
client disconnects, the port will be moved back to VLAN 1.
Displaying information on MAC address filters
and IP ACLs on an interface
You can display information about the user-defined and dynamically applied MAC address filters
and IP ACLs currently active on an interface.
Displaying MAC address filters applied to an 802.1x-enabled port
Use the show dot1x mac-address command to display information about MAC filters applied to an
interface. If the MAC address filter is dynamically assigned by 802.1x, the display shows the
following.
Brocade#show dot1x mac-address ethernet 1/1
Brocade# show interface e 1/3
GigabitEthernet1/3 is up, line protocol is up
STP Root Guard is disabled, STP BPDU Guard is disabled
Hardware is GigabitEthernet, address is 000c.dbe2.5800 (bia 000c.dbe2.5800)
Configured speed auto, actual 100Mbit, configured duplex fdx, actual fdx
Member of L2 VLAN ID 4094 (dot1x-RADIUS assigned), original L2 VLAN ID is 1,
port is untagged, port state is Forwarding
STP configured to ON, Priority is level0, flow control enabled
Priority force disabled, Drop precedence level 0, Drop precedence force disabled
dhcp-snooping-trust configured to OFF
mirror disabled, monitor disabled
Not member of any active trunks
Not member of any configured trunks
No port name
Internet address is 10.12.12.250/24, MTU 1522 bytes, encapsulation ethernet
300 second input rate: 810 bits/sec, 0 packets/sec, 0.00% utilization
300 second output rate: 1253 bits/sec, 1 packets/sec, 0.00% utilization
70178 packets input, 7148796 bytes, 0 no buffer
Received 0 broadcasts, 0 multicasts, 70178 unicasts
0 input errors, 0 CRC, 0 frame, 0 ignored
0 runts, 0 giants, DMA received 70178 packets
NP received 555904 packets, Sent to TM 555900 packets
NP Ingress dropped 4 packets
91892 packets output, 10081165 bytes, 0 underruns
Transmitted 9853 broadcasts, 13330 multicasts, 68709 unicasts
0 output errors, 0 collisions, DMA transmitted 91892 packets
NP transmitted 4278949 packets, Received from TM 4768301 packets