Brocade Multi-Service IronWare Security Configuration Guide (Supporting R05.6.00) User Manual
Page 279
Multi-Service IronWare Security Configuration Guide
261
53-1003035-02
Using Secure Copy
5
Syntax: scp file-name user@IP Address:Destination:file-name[:additional-options]
The last two tokens file-name and additional-options can be abbreviated. The others cannot be
abbreviated.
Auxiliary flash command option
To download a file and store it in a Auxiliary flash (Slot 1 or Slot 2), enter the following command
(not applicable to the CES or CER).
C:> scp
This commands transfers src-file to the device and saves it as /slot1/dst-file.
Flash MP command options
To download a file and store in MP Flash, enter the following command.
C:> scp
This command transfers src-file to the device and saves it as dst-file in flash
To download and replace MP Monitor image in Flash, enter the following command.
C:> scp
This command transfers monitor-image-file to the device and replaces MP monitor image in
flash.
To download and replace MP Primary image in Flash, enter the following command.
C:> scp
This command transfers primary-image-file to the device and replaces MP Primary image
in flash.
To download and replace MP secondary image in Flash, enter the following command.
C:> scp
This command transfers secondary-image-file to the device and replaces MP secondary
image in flash.
To download and replace MP boot image in Flash, enter the following command.
C:> scp
This command transfers boot-image-file to the device and replaces MP boot image in flash.
Running configuration command options
To download a configuration file and append to running configuration, enter the following
command.
C:> scp
This command transfers config-file to the device and appends to the running configuration.
When a configuration file is loaded using the Secure Copy feature, the following commands within
the configuration file are supported.
•
isis metric command
•
set-overload-bit command
•
admin-group