Brocade Multi-Service IronWare Security Configuration Guide (Supporting R05.6.00) - Manual (Page 272)

254 Multi-Service IronWare Security Configuration Guide
53-1003035-02
SSH server version 2 support
5
The show who command also displays information about SSH server connections.
Example
Syntax: show who [| begin expression | exclude expression | include expression ]
Ending an SSH server connection
To terminate one of the active SSH server connections, enter the following command.
Brocade# kill ssh 1
Syntax: kill ssh connection-id
Outbound SSHv2 client
SSH2 client allows you to connect from a Brocade device to an SSH2 server, including another
Brocade device that is configured as an SSH2 server. You can start an outbound SSH2 client
session while you are connected to the device by any connection method (SSH2, Telnet, console).
Brocade devices support one outbound SSH2 client session at a time.
The supported SSH2 client features are as follows:
• Encryption algorithms, in the order of preference:
• aes256-cbc
• aes192-cbc
• aes128-cbc
• 3des-cbc
• SSH2 client session authentication algorithms:
• Password authentication
Brocade#show who
Console connections:
established, monitor enabled, in config mode
2 minutes 17 seconds in idle
Telnet connections (inbound):
1 closed
2 closed
3 closed
4 closed
5 closed
Telnet connection (outbound):
6 closed
SSH connections:
1 established, client ip address 10.43.2.4, user is hanuma
1 minutes 16 seconds in idle
2 established, client ip address 10.50.3.7, user is Mikaila
you are connecting to this session
18 seconds in idle
3 established, client ip address 10.47.8.20, user is Jenny
1 minutes 39 seconds in idle
4 established, client ip address 10.55.3.9, user is Mariah
41 seconds in idle
5 established, client ip address 10.9.4.11, user is Logan
23 seconds in idle