Brocade Multi-Service IronWare Security Configuration Guide (Supporting R05.6.00) - Manual (Page 109)

Multi-Service IronWare Security Configuration Guide 91
53-1003035-02
Displaying Layer-2 ACLs
2
Displaying Layer-2 ACL statistics on Brocade NetIron CES and Brocade
NetIron CER devices
To display Layer 2 inbound ACL statistics on Brocade NetIron CES and Brocade NetIron CER
devices, enter commands such as the following.
To display Layer 2 outbound ACL statistics on Brocade NetIron CES and Brocade NetIron CER
devices, enter commands such as the following.
show access-list accounting int_type slot/port in | out l2
(config-if-e10000-14/1)#show access-list acc eth 14/1 in l2
Collecting L2 ACL accounting for 400 on port 14/1 ... Completed successfully.
L2 ACL Accounting Information:
Inbound: ACL 400
0: permit enable-accounting any any 100 etype ipv4-l5
Hit count: (1 sec) 0 (1 min) 0
(5 min) 0 (accum) 0
1: deny any any any etype arp
Hit count: Accounting is not enabled
2: deny enable-accounting tcp any any log
Hit count: Accounting is not available due to deny logging
(config-if-e10000-14/1)#show access-list acc eth 14/1 out l2
Collecting L2 ACL accounting for 400 on port 14/1 ... Completed successfully.
L2 ACL Accounting Information:
Outbound: ACL 400
0: permit enable-accounting any any 100 etype ipv4-l5
Hit count: (1 sec) 0 (1 min) 0
(5 min) 0 (accum) 0
1: deny any any any etype arp
Hit count: Accounting is not enabled
2: deny enable-accounting tcp any any log
Hit count: Accounting is not available due to deny logging