Commands, Clearing the acl statistics – Brocade Multi-Service IronWare Security Configuration Guide (Supporting R05.6.00) User Manual
Page 179
Multi-Service IronWare Security Configuration Guide
161
53-1003035-02
Commands
3
The policy-based-routing parameter limits the display to policy-based routing accounting
information. This option is only available for incoming traffic.
The rate-limit parameter limits the display to rate limiting ACL accounting information.
NOTE
If the ACL definition is modified after it is applied to the interface, then discrepancy may exist in the
ACL accounting information
Clearing the ACL statistics
Statistics on the ACL account report can be cleared:
•
When a software reload occurs
•
When the ACL is bound to or unbound from an interface
•
When you enter the clear access-list command, as in the following example.
Brocade(config)# clear access-list all
Syntax: clear access-list all | ethernet slot/port | ve ve-num
Enter all to clear all statistics for all ACLs.
Use ethernet slot/port to clear statistics for ACLs bound to a physical port.
Use ve ve-number to clear statistics for all ACLs bound to ports that are members of a virtual
routing interface.
Commands
The following commands support the features described in this chapter:
•
clear access-list receive accounting
•
•
•
•
•
•