Brocade Multi-Service IronWare Security Configuration Guide (Supporting R05.6.00) - Manual (Page 188)

170 Multi-Service IronWare Security Configuration Guide
53-1003035-02
suppress-acl-seq
3
suppress-acl-seq
Hides or suppresses the display and storage of sequence numbers for ACL entries. The no version
of this command resets the configuration to the default value.
Syntax suppress-seq-num
no suppress-seq-num
Command
Default
By default, suppress-seq-num is turned OFF.
Parameters None
Command
Modes
acl-policy subconfiguration mode
Usage
Guidelines
Multi-Service IronWare R05.6.00 supports ACL entry sequence numbers. If you want to downgrade
a device to an earlier version of software, you should enable suppress-acl-seq prior to the
downgrade. Otherwise, ACL configurations created with the sequence parameter on R05.6.00 will
not be allowed on older releases and will result in an error
Examples The following example suppresses ACL entry sequence numbering:
Brocade(config)# acl-policy
Brocade(config-acl-policy)# suppress-acl-seq
History
Related
Commands
acl-policy
Release Command History
Multi-Service IronWare R05.6.00 This command was introduced.