Brocade FastIron SX, FCX, and ICX Diagnostic Reference User Manual
Page 88
76
Brocade FastIron SX, FCX, and ICX Diagnostic Reference
53-1003076-02
NTP debug commands
4
This command displays information about the NTP server and peer association. Command output
resembles the following example.
Brocade# debug ip ntp association
NTP: peer_clear: peer 10.25.96.13 next 646 refid INIT
NTP: newpeer: 10.25.96.13 mode client vers 4 poll 6 10 key 00000000
Flags Flags -> iBURST
SYSLOG: <14>Mar 21 17:44:33 Murali NTP: client association is mobilized for
10.25.96.13.
SYSLOG: <14>Mar 21 17:44:33 Murali NTP: The system clock is not synchronized to
any time source.
SYSLOG: <14>Mar 21 17:44:40 Murali NTP: Stratum is changed to 2.
SYSLOG: <14>Mar 21 17:44:40 Murali NTP: System clock is synchronized to
10.25.96.13.
debug ip ntp broadcast
Syntax: [no] debug ip ntp broadcast
This command displays information about the NTP broadcast server and client. Command output
resembles the following example.
Brocade# debug ip ntp broadcast
Oct 19 18:32:46 NTP: ntp_timer: interface mgmt1 is up, we may send broadcast
packet
Oct 19 18:32:49 NTP: Sending NTP broadcast packet to subnet 10.20.111.255 via port
mgmt1
Oct 19 18:33:56 NTP: Sending NTP broadcast packet to subnet 10.20.111.255 via port
mgmt1
debug ip ntp clockadjust
Syntax: [no] debug ip ntp clockadjust
This command displays information about the NTP clock-adjust process. Command output
resembles the following example.
Brocade# debug ip ntp clockadjust
NTP: ntp_clock_update: at 327 sample 327 associd 3
NTP: ntp_local_clock: hufbuf - ptr 1 mindly 0.23329046 huffpuff correction
-0.00067095
NTP: ntp_local_clock: clk offset 0.00917431 clk jit 0 clk stab 0 sys_poll 6
NTP: ntp_set_freq: drift 0.00000010, old freq 50000000
NTP: ntp_set_freq: new freq 49999995
NTP: ntp_adj_host_clock: new offset 0.00917431, freq 49999995
NTP: Adjusting the clock. offset 0.00917431, calib used 251687
NTP: After adjusting the clock. offset 0.00817431, calib used 252687
NTP: Adjusting the clock. offset 0.00817431, calib used 252687
NTP: After adjusting the clock. offset 0.00717431, calib used 253687
NTP: Adjusting the clock. offset 0.00717431, calib used 253687
debug ip ntp errors
Syntax: [no] debug ip ntp errors
This command displays information about the NTP error events.