Brocade FastIron SX, FCX, and ICX Diagnostic Reference - Manual (Page 195)

Brocade FastIron SX, FCX, and ICX Diagnostic Reference 183
53-1003076-02
supportsave commands
8
This command enables the header to be displayed for all show commands being executed on CLI.
The header format is modified to include the following information:
• BEGIN - Indicates the command that will begin execution next.
• CONTEXT - Indicates in which session the command is executed.
• TIME STAMP - A time stamp, with millisecond granularity, helps to determine time difference
between separate runs of the same command.
• HW/SW INFO - Indicates the hardware and software version information.
The following sample output of show cpu command shows the modified header format.
Brocade# supportsave info enable
Brocade# show cpu
==========================================================================
BEGIN : show cpu
CONTEXT : CONSOLE#0
TIME STAMP : 12:09:19.238 GMT+05:30 Wed Nov 06 2013
HW/SW INFO : ICX6610-48-HPOE/FCXR08010b1
==========================================================================
1 percent busy, from 1689 sec ago
1 sec avg: 1 percent busy
5 sec avg: 1 percent busy
60 sec avg: 1 percent busy
300 sec avg: 1 percent busy
supportsave info disable
Syntax: supportsave info disable
This command disables the header to be displayed for all show commands being executed on CLI.
Recovery during continuous reload
Perform the following steps to collect the logs in case of continuous reload of the device on a given
partition:
• Press b to stop reloading in boot prompt.
• Boot from the stable firmware from the other partition using boot_primary or boot_secondary
options.
• Run supportsave command to collect the logs after the reload is finished with the stable
firmware.
• Execute the use default-configuration command from the boot prompt for stopping the start up
configuration during reload, and make sure the device loads successfully. Otherwise, contact
the Brocade technical support for assistance.