Brocade FastIron SX, FCX, and ICX Diagnostic Reference - Manual (Page 66)

54 Brocade FastIron SX, FCX, and ICX Diagnostic Reference
53-1003076-02
debug pp-bum-trunk-hash
3
debug pp-bum-trunk-hash
Traces and displays the output port through which a given packet can be sent out in a trunk for a
broadcast, unknown-unicast, and multicast (BUM) flow.
Syntax debug pp-bum-trunk-hash ingress_port sw_trunk_id dmac smac
ipv4 dst_ipv4 src_ipv4 [dst_tcp | udp_port] [src_tcp | udp_port] vlan vidx
ipv6 flow_label dst_ipv6 src_ipv6 [dst_tcp | udp_port] [src_tcp | udp_port] vlan vidx
non-ip
no debug pp-bum-trunk-hash
Parameters ingress_ port Specifies the ingress port number.
sw_ trunk_ id Specifies the software trunk ID.
dmac Specifies the destination MAC address.
smac Specifies the source MAC address.
ipv4 Generates debugging information related to IPv4 distribution for a BUM flow.
ipv6 Generates debugging information related to IPv6 distribution for a BUM flow.
The following variables are supported with the ipv4 and ipv6 options.
dst_ipv4 Specifies the destination IPv4 address.
src_ipv4 Specifies the source IPv4 address.
dst_tcp | udp_port
Specifies the destination TCP or UDP port number.
src_tcp | udp_port
Specifies the source TCP or UDP port number.
vlan Specifies the VLAN ID.
vidx Specifies the multicast ID.
flow_label Specifies the flow label in the IPv6 header.
dst_ipv6 Specifies the destination IPv6 address.
src_ipv6 Specifies the source IPv6 address.
non-ip Generates debugging information related to non-IP distribution for a BUM
flow.
Modes Privileged EXEC mode
Examples For the IPv4 BUM flow, the command output resembles the following example.
Brocade# debug pp-bum-trunk-hash 1/1/1 3 0000.00aa.aaaa 0000.00bb.1111 ipv4
10.1.1.1 10.1.1.2 10 10 1 100
Designated Trunk Port = 1/1/5
For the IPv6 BUM flow, the command output resembles the following example.