Brocade FastIron SX, FCX, and ICX Diagnostic Reference - Manual (Page 161)

Brocade FastIron SX, FCX, and ICX Diagnostic Reference 149
53-1003076-02
IGMP debug commands
6
debug ip igmp rx
Syntax: [no] debug ip igmp rx
This command displays the IGMP packets received.
Brocade# debug ip igmp rx
Brocade# debug ip igmp protocol query
IGMP.VRF1: Query Port 1/1/3*1/1/14,v25 Grp 0.0.0.0
IGMP.QRY: [ Port 1/1/3*1/1/14,v25. Grp 0.0.0.0 ]. Processing version 2 query
IGMP.VRF1: Query Port 1/1/3*1/1/14,v25 Grp 0.0.0.0
IGMP.QRY: [ Port 1/1/3*1/1/14,v25. Grp 0.0.0.0 ]. Processing version 2 query
und allIGMP.VRF3: Query Port 1/1/3*1/1/14,v26 Grp 0.0.0.0
IGMP.QRY: [ Port 1/1/3*1/1/14,v26. Grp 0.0.0.0 ]. Processing version 2 query
debug ip igmp show
Syntax: debug ip igmp show
This command displays the IGMP debug settings. Do not use the show debug command for this
purpose. The show debug command displays general debug information.
Brocade# debug ip igmp show
igmp debug-enable-any = 1
debug ip igmp port-down is enabled
debug ip igmp detail is enabled
debug ip igmp level 2 is enabled
debug ip igmp source
Syntax: [no] debug ip igmp source ipaddr
This command matches the source of the control packet or IGMP V3 source packets. The ipaddr
variable specifies the IP address of the IGMP source.
Brocade# debug ip igmp source 16.16.16.222
Brocade# IGMP: rcvd Report-V2(t=22) g=239.0.0.5 resp=100, pkt S=16.16.16.222 to
239.0.0.5, on v16 (phy 1/1/8), igmp_size=8
debug ip igmp timer
Syntax: [no] debug ip igmp timer
This command monitors the IGMP timer activity.
Brocade# debug ip igmp timer
monitor timer activity
debug ip igmp tx
Syntax: [no] debug ip igmp tx
This command displays the IGMP packets transmitted.
Brocade# debug ip igmp tx
Brocade# debug ip igmp protocol query
IGMP.VRF2: [ Port 1/1/3*1/1/14,v21. Grp 0.0.0.0 ] Sent version 2 Query. size 8.
Src 21.0.0.6
IGMP.VRF2: [ Port 1/1/3*1/1/14,v21 ] Sent General Query version 2 using src
21.0.0.6