Brocade FastIron SX, FCX, and ICX Diagnostic Reference - Manual (Page 205)

Brocade FastIron SX, FCX, and ICX Diagnostic Reference 193
53-1003076-02
show tech-support
9
show tech-support l3 ipv4-uc
Syntax: show tech-support l3 ipv4-uc
This command displays the following debugging information related to the Layer 3 IPv4 unicast
configurations:
• IPv4 routing table
• IPv4 interface
• Routing Information Protocol (RIP) routes and neighbors
• Border Gateway Protocol (BGP) routes and neighbors
• Open Shortest Path First Version 2 (OSPFv2) routes and neighbors
The following example shows the truncated output of the show tech-support l3 ipv4-uc command.
Brocade# show tech-support l3 ipv4-uc
IP Cache:
--------
Total number of cache entries: 5
D:Dynamic P:Permanent F:Forward U:Us C:Complex Filter
W:Wait ARP I:ICMP Deny K:Drop R:Fragment S:Snap Encap
IP Address Next Hop MAC Type Port Vlan Pri
1 10.1.1.5 DIRECT 0000.0000.0000 PU n/a 0
2 10.18.243.32 DIRECT 0000.0000.0000 PU n/a 0
3 10.20.20.4 DIRECT 0000.0000.0000 PU n/a 0
4 10.21.21.40 DIRECT 0000.0000.0000 PU n/a 0
5 10.255.255.255 DIRECT 0000.0000.0000 PU n/a 0
IP Interfaces:
-------------
Interface IP-Address OK? Method Status Protocol
Eth 7/2 10.1.1.6 YES NVRAM admin. down down
Eth 7/9 10.1.1.5 YES NVRAM up up
Eth 7/10 10.20.20.4 YES NVRAM up up
Eth 7/24 10.21.21.40 YES NVRAM up up
Eth mgmt1 10.18.243.32 YES NVRAM up up
Ve 3000 10.1.1.2 YES NVRAM down down
IP Routing Table:
---------------
Total number of IP routes: 5, avail: 262139 (out of max 262144)
B:BGP D:Connected R:RIP S:Static O:OSPF *:Candidate default
Destination NetMask Gateway Port Cost Type
0.0.0.0 0.0.0.0 10.18.243.1 mgmt1 1 S
1 10.18.243.0 255.255.255.128 0.0.0.0 mgmt1 1 D
2 10.20.20.0 255.255.255.0 0.0.0.0 7/10 1 D
3 10.21.21.0 255.255.255.0 0.0.0.0 7/24 1 D
4 10.1.1.0 255.255.255.0 0.0.0.0 7/9 1 D
IP Routing Summary:
-----------------
IP Routing Table - 5 entries:
4 connected, 1 static, 0 RIP, 0 OSPF, 0 BGP
Number of prefixes:
/0: 1 /24: 3 /25: 1
IP Ospf Trap :
-------------
Interface State Change Trap: Enabled
Virtual Interface State Change Trap: Enabled
Neighbor State Change Trap: Enabled
Virtual Neighbor State Change Trap: Enabled