Brocade FastIron SX, FCX, and ICX Diagnostic Reference - Manual (Page 178)

166 Brocade FastIron SX, FCX, and ICX Diagnostic Reference
53-1003076-02
PIM-SM snooping debug commands
6
debug ip pim show
Syntax: debug ip pim show
This command displays the PIM debug settings. Do not use the show debug command for this
purpose. The show debug command displays general debug information.
Brocade# debug ip pim show
pim debug-enable-any = 1
debug ip pim level 2 is enabled
debug ip pim vrf
Syntax: debug ip pim vrf vrf_name
This command displays the PIM related debugging information for the specified VRF.
Brocade# debug ip pim vrf vrf1
Debug: Jan 1 21:46:55 PIM_CFG.VRF1: port v85, ena_mode Dis
Debug: Jan 1 21:46:59 PIM_CFG.VRF1: port v85, ena_mode Ena
Debug: Jan 1 21:48:14 PIM_CFG.VRF1: port v85, ena_mode Dis
Debug: Jan 1 21:48:17 PIM_CFG.VRF1: port v85, ena_mode Ena
PIM-SM snooping debug commands
The following commands display information related to the Protocol Independent Multicast Sparse
mode (PIM-SM) snoop debugging.
debug pimsm-snoop clear
Syntax: [no] debug pimsm-snoop clear
This command clears all the PIM-SM snooping debug settings.
debug pimsm-snoop control-source
Syntax: [no] debug pimsm-snoop control-source source_address
This command displays the PIM-SM snooping related debug information for the specified control
source address. Command output resembles the following example.
Brocade# debug pimsm-snoop control-source 10.27.27.2
Brocade# PIMv2 Hello from 10.27.27.2 port 1/1/12 on vlan 275
PIMv2 Join/Prune from 10.27.27.2 port 1/1/12 on vlan 275
PIMv2 Hello from 10.27.27.2 port 1/1/12 on vlan 275
PIMv2 Hello from 10.27.27.2 port 1/1/12 on vlan 275
PIMv2 Join/Prune from 10.27.27.2 port 1/1/12 on vlan 275
PIMv2 Hello from 10.27.27.2 port 1/1/12 on vlan 275
PIMv2 Hello from 10.27.27.2 port 1/1/12 on vlan 275
debug pimsm-snoop enable
Syntax: [no] debug pimsm-snoop enable
This command enables debugging of the PIM-SM snooping activity. Command output resembles
the following example.
Brocade# debug pimsm-snoop enable