Brocade FastIron SX, FCX, and ICX Diagnostic Reference User Manual

Page 45

Brocade FastIron SX, FCX, and ICX Diagnostic Reference

53-1003076-02

MCT debug commands

=================== Remote CCEP UP ===================

CLUSTER FSM: Received CCRR message from peer when CCP is up

CLUSTER FSM: cluster id 1, client id 300, old state: Local Up, event: Remote Up

CLUSTER FSM: Cluster ABC (Id: 1), client c1 (RBridge Id: 300) - Remote client CCEP

CLUSTER FSM: new state: Up, master: FALSE

===================== CCP Down ============================

CLUSTER FSM: cluster id 1, peer rbridge id 100, old state: CCP Down, event: CCP

Down

CLUSTER FSM: cluster id 1, peer rbridge id 100, old state: CCP Down, event: CCP

Down

CLUSTER FSM: cluster id 1, peer rbridge id 100, old state: CCP Down, event: CCP

Down

CLUSTER FSM: cluster id 1, peer rbridge id 100, old state: CCP Down, event: CCP

Down

======================== CCP getting established ==========================

CLUSTER FSM: new state: Loading

CLUSTER FSM: cluster id 1, peer rbridge id 100, old state: Loading, event: CCP Up

CLUSTER FSM: Received Loading-Done message from peer

CLUSTER FSM: cluster id 1, peer rbridge id 100, old state: Loading, event: Loading

Done

CLUSTER FSM: getting EVENT_ID_MCT_CCP_UP event

CLUSTER FSM(T=121842)main: cluster id 1, client id 300, old state: Init, event:

CCP Up

CLUSTER FSM(T=121842)main: new state: Local Deploy, master: FALSE

CLUSTER FSM: new state: CCP Up

CLUSTER FSM: Received CCRR message from peer when CCP is up

CLUSTER FSM: cluster id 1, client id 300, old state: Local Deploy, event: Remote

Deploy

CLUSTER FSM: Cluster ABC (Id: 1), client c1 (RBridge Id: 300) - Remote client

deployed

CLUSTER FSM: new state: Admin Up, master: FALSE

CLUSTER FSM: Received CCRR message from peer when CCP is up

If the debug cluster fsm client command is disabled, the output similar to the following is displayed.

Brocade# no debug cluster fsm client 300

CLUSTER fsm debugging is now OFF for client rbridge 300

debug cluster intf-mac

Syntax: [no] debug cluster intf-mac

This command displays interface MAC debug information for the cluster as shown in the following
example.

Brocade# debug cluster intf-mac

CLUSTER ROUTER MAC(T=1791244): sent to peer rbridge id 2, base mac address

0000.0021.a500, number of mac addresses 1

CLUSTER ROUTER MAC(T=1791244): received from peer rbridge id 2, router mac address

0000.0083.3200, number of mac addresses 1

debug cluster mdup

Syntax: [no] debug cluster mdup

This command displays MDUP debug information for the cluster as shown in the following example.