Brocade FastIron SX, FCX, and ICX Diagnostic Reference - Manual (Page 188)

176 Brocade FastIron SX, FCX, and ICX Diagnostic Reference
53-1003076-02
Web events debug commands
7
Debug: Jan 1 01:57:26 IPSEC,Policy: Creating flow [input use 'prot=OSPF
src=FE80::/10:0 dst=::/0:0' -> SA: ESP in spi=0x190 dst=FE80::] : ok
Brocade(config-ospf6-router)#Debug: Jan 1 02:02:21 IPSEC,Policy: Creating flow
[output use 'prot=OSPF src=FE80::/10:0 dst=::/0:0' -> SA: ESP out spi=0x190
dst=::] : ok
debug ipv6 ospf ipsec
Syntax: [no] debug ipv6 ospf ipsec
TThis command displays information about IPsec events. This command can show if IPsec is
actually providing its services to IPv6 OSPFv3. The following output shows success in the attempts
to provide various IPsec services to OSPFv3.
Brocade# debug ipv6 ospf ipsec
OSPFv3: ipsec debugging is on
Brocade(config-ospf6-router)# no area 0 auth ipsec spi 400 esp sha1
abcef12345678901234fedcba098765432109876Debug: Jan 1 02:22:09 OSPFv3:
ITC_AUTHENTICATION_CONFIG message received
Debug: Jan 1 02:22:09 OSPFv3: Auth timer started
Debug: Jan 1 02:22:09 OSPFv3: Key Rollover, for area 0.0.0.0, state change
NOT_ACTIVE->STARTED
Debug: Jan 1 02:22:09 OSPFv3: Key Rollover, for v9, state change
NOT_ACTIVE->STARTED
Web events debug commands
The following command displays information related to web debugging.
debug web events
Syntax: [no] debug web events
This command enables web events debugging.
Brocade# debug web events
web: Events debugging is on
Web authentication debug commands
The following commands display information related to the web authentication debugging.
debug webauth events
Syntax: [no] debug webauth events
This command enables debugging of web authentication events.
Brocade# debug webauth events
webauth: Events debugging is on
debug webauth timers
Syntax: [no] debug webauth timers