Link aggregation debug commands – Brocade FastIron SX, FCX, and ICX Diagnostic Reference User Manual
Page 62
50
Brocade FastIron SX, FCX, and ICX Diagnostic Reference
53-1003076-02
Link aggregation debug commands
3
[VXLAN]: Create vxlan egress ip tunnel for L2-tunnel 2 with index ffffffff
[VXLAN]: Success to create vxlan egress ip tunnel for L2-tunnel 2 with index
4c000002
[VXLAN]: Create Forward nextHop 65535 for L2-tunnel 2 on network port 1/1/2
[VXLAN]: Success to reuse Forward nexthop 66 for L2-tunnel 2 from L2-tunnel 1 on
network port 1/1/2
[VXLAN]: Create vxlan terminator for L2-tunnel 2
[VXLAN]: Fail to get vxlan terminator on device 0 : Entry not found
[VXLAN]: Success to create vxlan terminator for L2-tunnel 2
[VXLAN]: Success to create vxlan tables for L2-tunnel 2
debug l2-tunnel vxlan mapping
Syntax: [no] debug l2-tunnel vxlan mapping
This command enables debug of flows of VXLAN mapping creation, updation, and deletion.
Command output resembles the following example.
Brocade# debug l2-tunnel vxlan mapping
[VXLAN]: Create VXLAN map for port 1/1/1, vlan 31, vni 3100, L2-tunnel 1
[VXLAN]: Create VXLAN VPN for vni 3100
[VXLAN]: Success to create VXLAN VPN for vni 3100 with VPN 7000
[VXLAN]: Add access port 1/1/1, vlan 31 to vpn 7000
[VXLAN]: Success to create access egress nexthop 100004
[VXLAN]: Success to create access vxlan port 80000001 for access port 1/1/1 on
vlan 31 in vpn 7000
[VXLAN]: Add network port 1/1/2 to vpn 7000 with existing vxlan port 80000002 on
L2-tunnel 1
[VXLAN]: Success to add network port 1/1/2 to vpn 7000 with new vxlan port
80000002 on L2-tunnel 1
[VXLAN]: Success to create VXLAN map
Link aggregation debug commands
The trunk group feature allows you to manually configure multiple high-speed load-sharing links
between two Brocade Layer 2 switches or Layer 3 switches or between a Brocade Layer 2 switch
and Layer 3 switch and a server.
In addition to enabling load sharing of traffic, trunk groups provide redundant, alternate paths for
traffic if any of the segments fail. Trunk groups are manually configured aggregate links containing
multiple ports. The 802.3ad link aggregation protocol dynamically creates and manages trunk
groups.
NOTE
The terms "trunk group" and "link aggregation group" are used interchangeably in this document.
The following commands are used for troubleshooting trunk groups:
•
•